1. In the “Utilities” menu, select “Release steppers”.
2a. If printhead 1 is too far up, use the following sequence:
Push printhead 2 down until it releases from the cartridge.
Carefully push printhead 1 down a little bit.
Carefully push printhead 2 back into place.
In the “Utilities menu”, select “Home printheads”.
In the “Utilities menu”, select “Raise printheads”.
Control if the difference between the printheads is less than 2 mm.
If it is not, return to 2a or 2b. If it is, proceed to step 3.

2b. If printhead 2 is too far down, use the following sequence:
Push printhead 1 down until it releases from the cartrige.
Carefully push printhead 2 up a little bit.
Carefully push printhead 1 back into place.
In the “Utilities menu”, select “Home printheads”.
In the “Utilities menu”, select “Raise printheads”.
Control if the difference between the printheads is less than 2 mm.
If it is not, return to 2a or 2b, if it is, proceed to step 3.

3. Use the following sequence to fine tune the height of the printheads:
Adjust set screw on the right side of printhead 2.
In the “Utilities menu”, select “Home printheads”.
In the “Utilities menu”, select “Raise printheads”.
Control if the printheads are completely level. If not, repeat the sequence.